Posts Tagged “sgs”

The rubber hits the road. Sort of.

Now that the hull is (almost) complete, it's time to start soldering the electronics into place.
Now that the hull is (almost) complete, it's time to start soldering the electronics into place.

Due to other, exciting distractions (which I will mention in a later post), I haven’t had a chance to keep the blog up to date. Still, work progresses on the boat, and that’s the important part. Last month, with the keel now in its new position about 30mm further back along the hull, and sealed into place, it was time to add the electronics board.

Read More

Sailboat Guidance System

20131027-124659.jpg

A quick look at the almost-complete Sailboat Guidance System (SGS). The board on the left is Igor. Otto is on the right, and the main CPU (Mother) is hidden underneath. The ribbon cable brings all the I/O to and from the boards. The red insulating tape is to remind me of some of the last remaining wires which need to be connected. You can also just about make out the DC/DC converter which is just underneath the ribbon cable at the bottom of the picture.

The new rudder

Thanks go to Colman Corrigan for designing and building the keel and rudder. The keel follows the traditional NACA shape, with a rounded leading-edge, tapering off to a narrow trailing edge. It is approximately a 6318 shape, with the maximum width being about 36% of the length of the cross-section. Overall, the keel is coming in at about 750mm from hull to the end of the bulb, and about 240mm from front to back. That’s a 3:1 aspect ratio.

Read More